Dimplex BF39ST Service Manual download pdf (Page 8)

LightBulbReplacement

Allow at least ve (5) minutes for light bulbs to cool before

touching bulbs to avoid accidental burning of skin.

Light bulbs need to be replaced when you notice a dark

section of the ame or when the clarity and detail of the log

ember bed exterior disappears. There are four (4) bulbs

under the log set, which generate the ames and embers,

and two (2) bulbs above the log that illuminate the log

exterior.

HelpfulHints

It is a good idea to replace all light bulbs at one time if they

are close to the end of their rated life. Group replacement

will reduce the number of times you need to open the unit to

replace light bulbs. Care must be taken when removing the

log set as the log set contains LED’s and wires.

LowerLightBulbRequirements

Quantity of four (4) clear chandelier or candelabra bulbs with

an E-12 (small) socket base, 60 Watt rating. Example: GE

60BC or Philips 60 CTC.

Donotexceed60Wattsperbulb

Toaccessthelowerlightbulbarea(Figure5):

1. Disconnect power to fireplace.

2. Slide fireplace out from mantel.

3. Open the bi-fold doors and steel curtain.

4. Pull the front edge of the plastic ember bed or plastic

grate up and forward until the rear tab releases from the

ledge located at the bottom of the mirror.

IMPORTANT:Only handle the log set by the ember bed.

NOTE:Log set ts tightly into rebox, some force may

be necessary to remove.

5. Set log set in front of replace.

6. Disconnect the log set LED wire harness from unit

(Figure 5).

7. Pull the Flicker Rod to the far right, then bend it carefully

to free and lift the left side out of the mounting bracket.

 NOTE: When removing the Flicker Rod, damage may

occur if bent excessively. If the Flicker Rod is damaged,

replace to insure proper operation.

8. Replace bulb(s) as needed.

9. Reinstall the Flicker Rod.

10. Reconnect the log set LED wire harness.

11. Replace the log set by inserting the rear edge of the log

set and push down on the front edge of the ember bed

until it snaps into place (Figure 6).

NOTE:Ensure the log set is installed tightly under the

back ledge to prevent light leakage.

Light Bulb

LED Wire

Harness

Log Set

Figure 5

Side Section

Front

Edge

Log

Ember bed

Back

Ledge

Rear

Tab

Figure 6

12. Close steel curtain and bi-fold doors.

13. Replace replace into mantel.

UpperLightBulbRequirements

Quantity of two (2) clear chandelier or candelabra bulbs with

an E-12 (small) socket base, 25 Watt rating.

Donotexceed25Wattsperbulb

Toaccesstheupperlightbulbarea(Figure7):

1. Open bi-fold doors and steel curtain.

2. Upper bulbs are located in the upper left and upper right

corners of replace.

Light

Bracket

Upper Light

Screw

Figure 7

1 2 3 4 5 6 7 8 9 10 11 12 13 14

Comments to this Manuals

No comments

Dimplex BF39ST Service Manual Page 8

Comments to this Manuals

Related products and manuals for Fireplaces Dimplex BF39ST