3
Operation
ElectricFireplaceManualControl
The manual controls for the replace are located in the upper
right hand corner (Figure 1).
A. MainOn/OffSwitch
Supplies power to the 3 position manual control switch.
B. 3PositionManualControlSwitch
Remote(leftposition): The unit is operated with the remote
control.
Flame(centerposition): The ame effect is turned ON.
**Flame&Heat(rightposition): The ame effect and
heater are turned ON simultaneously. When the manual
control is in the Flame&Heatposition the heater does not
run on the remote operated thermostat. When the heater is
ON the red indicator light is activated on the rebox and the
fan and heater are running on low.
!
NOTE:When the manual control switch is in the Flame
and Flame&Heatpositions, the replace unit will not
operate with the remote control.
ResettingTheTemperatureCutoffSwitch*
Should the heater overheat, an automatic switch will turn the
heater off and it will not come back on without being reset.
The temperature cutoff switch can be reset by unplugging the
unit, waiting 5 minutes and plugging the unit back in.
CAUTION:If you need to continuously reset the heater,
unplug the unit and call Dimplex North America Limited at
1-888-346-7539 for technical support.
*NotapplicableonDF3215NHmodelreplaces.
**FlameonlyfunctionofDF3215NH
RemoteControl
The remote control has a range of approximately 50 ft.
(15.25m). It does not have to be pointed at the replace
and can pass through most obstacles (including walls). It
is supplied with 243 independent frequencies to prevent
interference with other units.
BatteryInstallation
1. Depress tab on the battery cover on the back of the
remote transmitter and remove battery cover (Figure 2).
Figure 2
Batteries
Child Lock
Unlocked
Locked
Child Lock Tab
Figure 1
A
B
Indicator
Light
Initialization
Button
2. Install two (2) AAA batteries into the remote control
(included).
3. Ensure child lock is in the “unlocked” position.
4. Replace the battery cover.
!
NOTE:When the
symbol is present on the
remote control it is recommended to replace the batteries
promptly, to maintain full functionality of the remote/
replace. The remote transmitter has a battery backup
time of only several hours.
InitializingTheRemoteControl
1. Plug cord into 120 Volt wall outlet.
2. Ensure the Main On/Off switch located in the switch box
in the replace in the upper right hand corner is in the On
position.
3. Set the 3 position manual control to the Remote position
(left position).
4. Press and hold the initialization button on the unit.
5. While holding the initialization button, press the Flame/
Heat On/Off button
or the Purire™ On/Off
button on
the remote control transmitter.
6. Release the initialization button on the unit.
7. Press the Flame/Heat On/Off button
to turn the Flame/
Comments to this Manuals