9
3. Remove the light cover for each bulb (one (1) Philips
screw each).
4. Unscrew bulbs counter clockwise.
5. Insert new bulbs.
6. Re-install upper light bracket.
7. Close steel curtain and bi-fold doors.
Purire™FilterReplacement
The Purire™ lter supplied in the replace is reusable
and washable. The lter should be cleaned or replaced
on average once a year. To clean the lter gently tap lter
on a hard surface to dislodge any loose dirt or debris,
and then clean with water. No soap or cleaning products
are recommended. The lter size is 20” X 10” X 1” rated
at MERV 10. If using an after market lter follow the
manufacturers recommended replacement instructions.
Toreplacelter:
Open the bi-fold doors.1.
Remove the three (3) mounting screws from the air lter 2.
bracket (Figure 8).
Remove the air lter bracket assembly from the rebox.3.
Slide lter out of air lter bracket.4.
Reassemble in reverse order as above.5.
2. Lay replace on its back.
3. Remove the 10 Philips screws that attach the bottom
panel to the replace as shown in Figure 9. There are:
two (2) screws along the bottom edge of each side;
two (2) screws immediately behind the front trim piece;
and two (2) screws along the back, bottom edge of the
replace.
Air
Filter
Air Filter
Bracket
Mounting
Screws
Figure 8
MirrorReplacement
If the replace was operating prior to servicing allow at least
10 minutes for light bulbs and heating element to cool off to
avoid accidental burning of skin.
Disconnect power before attempting any maintenance or
cleaning to reduce the risk of electric shock or damage to
persons.
ReplacementProcedure
1. Slide fireplace out from mantel.
!
NOTE:Use caution when removing bottom panel as
there are components attached to the panel which are
hard wired within the replace chassis.
!
NOTE:The bi-fold doors are supported by the bottom
panel. When pulling the bottom panel away from the
chassis, do so carefully so that the doors do not get
damaged.
4. Carefully remove bottom panel from replace and swivel
it outwards to the right so as to keep wiring connected
but allowing sufcient room to work.
5. Slide the bi-fold doors out of the top frame track and set
aside.
6. Disconnect the log set LED wire harness.
7. Remove the six (6) Philips screws that hold the log set
support bracket in place. Refer to Figure 10 for a side
view of the replace showing screw locations.
!
NOTE:Some replaces have these three points riveted
instead of screwed in place. If this is the case, use a 1/8
inch drill bit to drill out the rivet.
Figure 9
Rear view of replace
Figure 10
Front of
Fireplace
3 Screws to remove (per side)
8. Remove the log set and set aside.
9. Referring to Figure 11, the sides of the log set support
bracket are aligned within the rubber extrusions of the
Comments to this Manuals