Dimplex BFSL33 Installation Guide download pdf (Page 8)

www.dimplex.com

IMPORTANT: The unit is factory congured for 208/240V operation.

NOTE: Use 2 conductor wires with ground (3 wires total) from the power

supply (breaker panel) to the junction box on the unit.

NOTE: All wiring must be completed prior to installing the unit.

NOTE: Ensure that the voltage selector switch is in the proper position for

the required supply voltage prior to connecting the unit to the power sup-

ply.

Locate the voltage selector switch inside the exhaust panel on the top 1.

right hand corner of the unit. Flip the switch from 240V to 120V congu-

ration. (230 and 115 is printed on switch)

Loosen the screw securing the junction box cover and remove the cover.2.

Remove the knockouts (if necessary) or use the provided cable clamp.3.

Pull out the four wires marked L1, L2, N, and G.4.

Connect L1 (black) wire from the unit to the L1 (black) from the power 5.

supply.

Connect L2 (red) and N (white) from the unit to the Neutral (white) from 6.

the power supply.

Connect the ground wire (green) from the unit to the ground from the 7.

power supply.

When the unit has been congured for the appropriate power supply volt-8.

age, ensure that all connections are tight.

Insert all the wiring back into the unit and secure with a cable clamp.9.

FIREPLACE JUNCTION BOX

120 V

POWER

SUPPLY

(BREAKER

PANEL)

WHITE WIRE - N

RED WIRE –

BLACK WIRE – L1

WHITE WIRE - N

BLACK WIRE – L1

GROUND WIRE - G

GREEN WIRE - G

120V INSTALLATION

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 18 19

No comments

Dimplex BFSL33 Installation Guide Page 8