Dimplex BFSL33 Installation Guide download pdf (Page 5)

SECTION B: GENERAL ELECTRICAL INFORMATION

For 120V installations • use two conductor, non-metallic sheath cable with

ground wire (3 wires total) for the incoming power supply on replace in-

serts. Use the appropriate wire to meet local and national electrical codes

for rated power consumption.

For 208V / 240V installations• use three conductor, non-metallic sheath

cable with ground wire (4 wires total) for the incoming power supply on

replace inserts. Use the appropriate wire to meet local and national elec-

trical codes for rated power consumption.

Two conductor, non-metallic sheath cable with ground wire (3 wires total) is

recommended for installation of a wall mounted thermostat and/or wall switch

for use on replace inserts. Use appropriate wire to meet local and national

electrical codes for rated power consumption. All wire gauges should match

the recommended wire sizes shown below.

Voltage Wire Gauge Fuse Rating

120 Volts 12 Gauge 15 Amp

208 Volts 12 Gauge 15 Amp

240 Volts 12 Gauge 15 Amp

NOTE: The trim should be in-

stalled before securing the rebox in

the opening.

There are two mounting anges

located on each side of the replace

insert.

From the inside of the unit, bend tabs

outward and mount to the inside of

the framing using suitable hardware.

Mounting

Flanges

MOUNTING FLANGES

RECOMMENDED POWER SUPPLY WIRE SPECIFICATIONS

Figure 3

1 2 3 4 5 6 7 8 9 10 ... 18 19

No comments

Dimplex BFSL33 Installation Guide Page 5