Dimplex QSH-125 Owner's Manual download pdf (Page 8)

8 www.renewables.dimplex.com

Installation Instructions

terminal marked L

• Ensure the red wire is connected to the

terminal marked L

• The ground wire should be connected to the

terminal marked E or .

NOTE: For 208V installations the wiring must be

modied for the motor to operate correctly.

• 208V installations ONLY: Disconnect one end

of the the blue wire on T6 and connect it to T5.

3. The main power entry clamp and terminal block

will be visible on the right hand side of the unit.

Insert the power cables through the opening at

the bottom of the heater and connect. (Figure

CAUTION: Only heat resistant wiring should be

used, capable of withstanding temperatures up to

90°C (194°F).

Building the Center Core

1. Remove the inner panel to access the core of

the heater. Lay the inner panel carefully to one

side to ensure it is not damaged. (Figure 10)

2. Remove any internal packaging.

3. The bricks have several grooves on one

surface for locating around the elements. The

two slots through the centre of the brick create

the air passages within the core.

4. Position the rst brick of the bottom row to the

right rmly pressed against the side insulation

with the element grooves facing upwards and

tting neatly around the element. Angle the

element upward to t the brick and the air

passages line up with the holes in the base

insulation.

CAUTION: Do not disconnect the element

terminals

5. Fit the remaining bricks in the bottom row being

careful not to damage or dislodge the element.

6. Position the second row of bricks so that they

are facing down and the element sits within the

grooves. (Figure 11)

Wire Entrance

Cable Clamp

Terminal

Block

Figure 9

Figure 10

208/240V Installations

1 2 3 4 5 6 7 8 9 10 11 12 13 14

Comments to this Manuals

No comments

Dimplex QSH-125 Owner's Manual Page 8

Comments to this Manuals

Related products and manuals for Space heaters Dimplex QSH-125