Dimplex QSH-125 Owner's Manual download pdf (Page 6)

6 www.renewables.dimplex.com

Site Selection and Preparation

1. Place the heater at on the ground with arrows

printed on the base of the carton pointing

upwards. Open the carton at the bottom,

slide the heater out of the carton exposing the

feet and the hardware kit located within the

packaging on the right hand side. Remove the

feet and the hardware kit.

2. Secure the feet to the heater, using the screws

provided in the hardware kit.

!

NOTE: For models QSH-70 and QSH-100

two locations are possible for mounting each

foot. They are indicated by an “X” and “Y”

marking visible on the base of the heater.

3. Ensure the feet are secured at the location

holes marked with an “X”, see Figure 3.

4. Stand the heater on its feet before removing

the packaging.

5. Once the feet have been secured and the unit

has been turned upright, remove the grille from

the side of the unit. (Figure 4)

6. Remove the two screws located towards the

bottom at each end of the heater, which retain

the heater sides. (Figure 5A)

7. Push the end panels vertically upwards to

release each side from its securing points.

(Figure 5B)

8. Remove the two screws securing the front

panel, located at the upper sides of the heater,

and swing the upper edge of the front panel

forwards and unhook it from along the heater

base. (Figure 6)

Figure 4

Figure 5

A

B

Figure 6

Figure 3

1 2 3 4 5 6 7 8 9 10 11 12 13 14

Comments to this Manuals

No comments