Dimplex DF2024 Service Manual download pdf (Page 7)

SWITCHBOARD REPLACEMENT

Tools Required: Phillips Head Screwdriver

Flat Head Screwdriver

CAUTION: If unit was operating prior to servicing allow

at least 10 minutes for lights, heating elements and top

panel to cool off to avoid accidental burning of skin.

WARNING: Disconnect power before attempting any

maintenance to reduce the risk of electric shock or damage

to persons.

1. Unplug the unit from power outlet.

2. Remove the rebox from the back of the mantel by

removing the retaining screws which secure the rebox

brackets to the mantel.

3. Remove the three screws along the back of the unit,

the two on either side along the top edge and the two

at the top of the glass retaining bracket on both sides.

(Figure 3)

4. Lay the Compact Fireplace on its back.

5. Gently open the top panel, laying it on the work sur-

face so that all of the components can easily be seen.

(Figure 4)

6. Locate the Switchboard and disconnect the wiring con-

nections noting their original locations.

NOTE: A at head screwdriver can be used to gently

pry between the end of the connector and the switch to

release the wires.

7. Remove the hardware securing the board to the unit.

8. Properly orient and install the switchboard and connect

all of the wiring.

9. Reassemble in the reverse order as above.

Figure 3

RELAY BOARD REPLACEMENT

Tools Required: Phillips Head Screwdriver

Flat Head Screwdriver

Needle Nose Pliers

CAUTION: If unit was operating prior to servicing allow

at least 10 minutes for lights, heating elements and top

panel to cool off to avoid accidental burning of skin.

WARNING: Disconnect power before attempting any

maintenance to reduce the risk of electric shock or damage

to persons.

1. Unplug the unit from power outlet.

2. Remove the rebox from the back of the mantel by

removing the retaining screws which secure the rebox

brackets to the mantel.

3. Remove the three screws along the back of the unit,

the two on either side along the top edge and the two

at the top of the glass retaining bracket on both sides.

(Figure 3)

4. Lay the Compact Fireplace on its back.

5. Gently open the top panel, laying it on the work sur-

face so that all of the components can easily be seen.

(Figure 4)

6. Locate the relay board and disconnect the wiring con-

nections noting their original locations.

NOTE: A at head screwdriver can be used to gently

pry between the end of the connector and the switch to

release the wires.

7. Release the relay board from the top panel by using

needle nose pliers to depress the tab on the mounting

standoffs and gently lift the board off.

8. Properly orient and insert the new board and connect

all of the wiring.

9. Reassemble in the reverse order as above.

Figure 4

Top Panel

Glass Retaining

Bracket

Switchboard

Power Supply

Relay

Board

Heater

Assembly

Power Cord

Display/Control Board

Securing Screws

1 2 3 4 5 6 7 8 9 10 11 12 13

Comments to this Manuals

No comments

Dimplex DF2024 Service Manual Page 7

Comments to this Manuals

Related products and manuals for Fireplaces Dimplex DF2024