Dimplex DF2024 Service Manual download pdf (Page 10)

10 www.dimplex.com

LED LIGHT ASSEMBLY REPLACEMENT

Tools Required: Phillips Head Screwdriver

CAUTION: If unit was operating prior to servicing allow

at least 10 minutes for lights, heating elements and top

panel to cool off to avoid accidental burning of skin.

WARNING: Disconnect power before attempting any

maintenance to reduce the risk of electric shock or damage

to persons.

1. Unplug the unit from power outlet.

2. Remove the rebox from the back of the mantel by

removing the retaining screws which secure the rebox

brackets to the mantel.

NOTE: Steps 3-5 are only applicable for units with

logset assemblies.

3. Remove the two screws that secure the front glass

retaining bracket to the unit. (Figure 5)

4. Remove the front glass and set aside in a safe place.

5. Remove the retaining screw in the front middle of the

grate.

6. Remove the three screws along the back of the unit

and the two on either side along the bottom edge.

(Figure 6)

7. Lay the Compact Fireplace on its back.

8. Gently open the bottom panel, laying it on the work sur-

face so that all of the components can easily be seen.

(Figure 7)

9. Locate the LED lights along the back. Each light is

secured with four screws and there is a light lter that is

sandwiched between the light assembly and the sheet

metal bracket.

NOTE: New light lters are not provided with replace-

ment lights and will need to be reinstalled in the original

locations.

10. There is one connection located on the display/control

board that requires the board to be removed. This can

be done by removing the two screws on the right hand

side of the unit, reaching between the partially reective

panel and the back of the unit, to remove the display/

control board to remove the connection and replace it

with the new one.

11. Reinstall the display/control board.

12. Properly orient and install the new LED lights and con-

nect all of the wiring.

13. Reassemble in the reverse order as above.

LOG SET ASSEMBLY REPLACEMENT

Tools Required: Phillips Head Screwdriver

CAUTION: If unit was operating prior to servicing allow

at least 10 minutes for lights, heating elements and top

panel to cool off to avoid accidental burning of skin.

WARNING: Disconnect power before attempting any

maintenance to reduce the risk of electric shock or damage

to persons.

1. Unplug the unit from power outlet.

2. Remove the rebox from the back of the mantel by

removing the retaining screws which secure the rebox

brackets to the mantel.

3. Remove the two screws that secure the front glass

retaining bracket to the unit. (Figure 5)

4. Remove the front glass and set aside in a safe place.

5. Remove the retaining screw in the front middle of the

grate.

6. Pull the front edge of the plastic Ember Bed or plastic

grate up and forward until the rear tab releases from

the ledge located at the bottom of the Partially Reect-

ive Panel. (Figure 8)

IMPORTANT: Only handle the Log Set by the Ember

Bed.

NOTE: Log Set ts tightly into rebox, some force may

be necessary to remove.

7. Reassemble in the reverse order as above.

Flicker Rod

Flicker

Motor

Terminal

Block

Figure 7

Side Section

Front

Edge

Log

Ember

Bed

Back

Ledge

Rear

Tab

Figure 8

LED Lights

Thermistor

1 2 ... 5 6 7 8 9 10 11 12 13

Comments to this Manuals

No comments

Dimplex DF2024 Service Manual Page 10

Comments to this Manuals

Related products and manuals for Fireplaces Dimplex DF2024