Dimplex BFSL33 Service Manual download pdf (Page 9)

13. Remove the light strip and harness.

14. Properly orient the new LED strip and reconnect all of

the wiring connections.

15. Reassemble in the reverse order as above.

NOTE: See Helpful Hints Section for reassembly.

REPLACEMENT INSTRUCTIONS:

UNITS SECURED IN WALL

ON/OFF SWITCH REPLACEMENT

Tools Required: Phillips Head Screwdriver

Flat Head Screwdriver

WARNING: If the replace was operating prior to

servicing allow at least 10 minutes for light bulbs and

heating elements to cool off to avoid accidental burning

of skin.

WARNING: Disconnect power before attempting any

maintenance or cleaning to reduce the risk of electric

shock or damage to persons.

1. Remove glass doors. (If applicable)

2. Open the steel curtains.

3. Release the steel curtains from the side panels by

opening the retainers on the sides of the replace using

needle nose pliers.

4. Remove the steel curtains by lifting up on the curtain

rod releasing it from the center bracket, then sliding

the rod out from the side mounting tab, and pulling out.

Repeat on other side.

5. Remove the 2 screws from the log set retaining plate

along the front of the log set and remove the retaining

plate.

6. Pull the rear edge of the log set forward by grasping

the ember bed by the sides, pull rmly until the rear tab

pops out from under the back ledge, then lift the logs

out. (Figure 3)

IMPORTANT: Only handle the log-set by the plastic

ember-bed, not the logs themselves.

NOTE: Log-set ts tightly into rebox. Some force

may be necessary to remove.

7. Unplug the log set LED wire harness from unit.

8. Loosen the screws on the 2 partially reective glass

retaining clips: bottom left side and bottom right side

of the rear partially reective glass panel and turn the

clips downward.

9. Carefully lift the partially reective glass out of the

replace and set aside in a safe location.

10. Remove the 8 screws from the upper air in-take panel

inside the rebox above the partially reective glass: 4

on the left and 4 on the right.

11. Once screws are removed lift the panel up from the

back, bowing it slightly in the center and pulling out by

one end.

NOTE: Wires from the switches are attached to this

panel, so use care when lowering the panel.

12. Carefully rest the panel inside the lower cavity of the

replace on its end with the switches near the top. Be

careful not to scratch the partially reective glass.

13. Depress the retainer clips on 2 sides of the switch and

push the switch out through the front face of the upper

air-intake panel.

14. Remove the wires attached to the switch noting the

original location and orientation.

NOTE: Using a at head screwdriver gently pry be-

tween the end of the connector and the switch to release

the wires.

15. Properly orient the new switch and reconnect all of the

wiring connections.

16. Reassemble in the reverse order as above.