Dimplex BFSL33 Service Manual Page 1

Service ManualModelBFSL33UL Part Number6905280100 7400440000R00In keeping with our policy of continuous product development, we reserve the right to m

10 www.dimplex.com10. Remove the 8 screws from the upper air in-take panel inside the rebox above the partially reective glass: 4 on th

11Repeat on other side.5. Remove the 2 screws from the log set retaining plate along the front of the log set and remove the retaining plate.6. Pull

12 www.dimplex.comhousing mounting tabs above the fan to drop and release from the top panel. 15. Locate the high-limit temperature cutou

13! NOTE: Log-set ts tightly into rebox. Some force may be necessary to remove.7. Unplug the log set LED wire harness from unit.8. Loosen the sc

14 www.dimplex.comfrom the front).5. Bring the mounting bracket down out of the rebox. Depress the retainer clips on both sides of the

15assembly, noting their original locations ! NOTE: Using a at head screwdriver gently pry be-tween the end of the connector and the switch to rele

16 www.dimplex.comREAR AND RIGHT SIDE INTERIOR PANELLOWER COMPONENT AREA(Logset and Partially Reective Glass Removed)ASSEMBLY COMPONENT P

17UPPER COMPONENT AREAHeater Assembly with Upper Vent Panel and Partially Reective Glass RemovedHeater Assembly Housing with High Limit Cut Out on th

18 www.dimplex.comPROBLEM CAUSE SOLUTIONGeneralCircuit breaker trips or fuse blows when unit is turned onShort in unit wiring. Trace wirin

19PROBLEM CAUSE SOLUTIONHeaterHeater is not turning off Improper operation Refer to Operation SectionDefective Remote Switchboard Replace Remote Switc

2 www.dimplex.comAlways use a qualied technician or service agency to repair this replace.! NOTE: Procedures and techniques that are c

3 CAUTION: If you need to continuously reset the heater, disconnect power and call Dimplex customer service at 1-888-DIMPLEX (1-888-346-7539).Remote

4 www.dimplex.comVoltage Selector SwitchThe BFSL33 has 2 voltage options at the time of installa-tion, 110/120v and 220/240v. The voltage

5EXPLODED PARTS DIAGRAMReplacement Parts: 1. Log Set Assembly ...0439560100RP2. Flicker Motor ...2000210100RP3. Blo

6 www.dimplex.comWIRING DIAGRAMDDDDDFFFZZZFFT120V/LO HEATFTTFFFDFFT2ADDZ240V/LO HEAT240V/HI HEAT120V/HI HEATPPPPPPFTTFFFFTTLED PCB BOARDP/

7REMOTE RECEIVER BOARD AND LOGSET DRIVER BOARD REPLACEMENTTools Required: Phillips Head ScrewdriverFlat Head Screwdriver WARNING: If the replace

8 www.dimplex.comconnectors will be found just in front of the board secured to other wires within the replace with plastic zip-ties.11.

913. Remove the light strip and harness.14. Properly orient the new LED strip and reconnect all of the wiring connections.15. Reassemble in the rev