
Owner’s ManualModel DFG2562DFG253A7210580100R09IMPORTANT SAFETY INFORMATION: Always read this manual rst before attempting to install or use this re
10 www.dimplex.com Installation Operation WARNING: This electric rebox must be properly installed before it is used.Manual ControlsA. 3-Position
11Figure 5CBAtil you hear the click again and the heater will turn on.!NOTE: The heater on your replace may emit a slight, harmless odor when rst
12 www.dimplex.comBattery Replacement (Figure 7)To replace the battery:1. Slide battery cover open on the remote control.2. Install one (1) 12-Vol
13 Maintenance WARNING: Disconnect power before attempting any main-tenance or cleaning to reduce the risk of re, electric shock or damage to perso
14 www.dimplex.comProducts to which this limited warranty applies This limited warranty applies to your newly purchased Dimplex electric replace. T
15Dimplex Technical Service by contacting Dimplex at 1-888-DIMPLEX (1-888-346-7539), or 1367 Industrial Road, Cambridge Ontario, Canada N1R 7G8. P
16 www.dimplex.com Warrantyof rst purchase, Dimplex will in its sole discretion either repair or replace such defective surrounds (mantels) and tr
17 Replacement PartsBlower Assembly (Cutout) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2200491100RPFlicker Motor ...
2 www.dimplex.com Table of ContentsAlways use a qualied technician or service agency to repair this replace.! NOTE: Procedures and techniques t
3 Welcome & CongratulationsThank you and congratulations for choosing to purchase an electric replace from Dimplex, the world leader in elect
4 www.dimplex.comWhen using electrical appliances, basic precautions should always be followed to reduce the risk of fire, electric shock, and injur
5SAVE THESE INSTRUCTIONSin this manual. Any other use not recommended by the manufactur-er may cause re, electric shock or injury to persons.⑮ To
6 www.dimplex.com!NOTE: This equipment has been tested and found to comply with the limits for Class B digital device, pursuant to part 15 of the FC
7 Installation WARNING: Ensure the power cord is not installed so that it is pinched or against a sharp edge and ensure that the power cord is st
8 www.dimplex.com Installation Figure 2Figure 3New Wall Construction1. Mark the desired location on the oor and store the re-place in a safe, dr
9 Installation consumption.2. Remove the outer jacket and strip the individual conductor from the end.3. Loosen the screw securing the junction b
Comments to this Manuals