Dimplex CFA36BS Service Manual download pdf (Page 3)

MAINTENANCE

 WARNING: Disconnect power before attempting

any maintenance or cleaning to reduce the risk of re,

electric shock or damage to persons.

NOTE: Even if the replace is not used regularly, the

battery should be fully recharged at minimum every three

(3) months to prolong battery life.

Partially Reective Glass Cleaning

The partially reective glass is cleaned in the factory during

the assembly operation. During shipment, installation,

handling, etc., the partially reective glass may collect dust

particles; these can be removed by dusting lightly with a

clean dry cloth.

To remove ngerprints or other marks, the partially

reective glass can be cleaned with a damp cloth. The

partially reective glass should be completely dried with a

lint free cloth to prevent water spots. To prevent scratching,

do not use abrasive cleaners.

Fireplace Surface Cleaning

Use only a damp cloth to clean painted surfaces of the

replace. Do not use abrasive cleaners.

Servicing

Except for battery replacement and cleaning described

above, an authorized service representative should perform

any other servicing.

OPERATION

Figure 1

This electric replace is operated by a momentary switch

located on the bottom of the replace, under the right hand

corner (Figure 1-A).

Press the momentary switch to toggle the replace’s ame

effect on or off.

The battery charge LEDs (Figure 1-B) will indicate the

charge level of the battery. The LEDs read green, yellow

and red from right to left. Once the red battery charge LED

is lit, the electric replace should be plugged in to recharge.

The replace can operate while charging.

NOTE: The replace will shut off automatically if it is

unplugged during operation. The momentary On/Off Switch

will need to be activated to turn the replace on again.

Charging Cord

1 2 3 4 5 6 7 8 9 10 11

No comments

Dimplex CFA36BS Service Manual Page 3