Dimplex DAC12004RC Specifications download pdf (Page 9)

Adding Water.

An added feature of these models.

Humidity absorbed from the air condenses at the Evaporator, turns into water and is

collected in the internal tank.When enough water is collected it is pumped up and over

the condenser, assisting the cooling of the refrigerated gas, increasing the COOLING

CAPACITY. Some of this recycled water is evaporated at condenser and expelled from

the machine as water vapour though the exhaust hose.

To utilise the full potential of your air conditioner from initial start up, we recommend

that 800 mls of water be added to the internal water tank via the small draw located at

the rear bottom left side of the machine.

Normally an adequate quantity of water is collected to keep the recycling process

operating.

During very humid conditions the collection of water

may over take the evaporation rate and the internal

tank may become full.

The maximum water level in the tank is controlled by

a float and micro switch, when the preset level is

exceeded the indicator above the ‘Power’ Switch will

light and the compressor will shut off automatically,

the fan motor will stay on circulating the air.

At this time, you must empty the water tank as

described “Drainage” page 11.

During low humidity it maybe necessary to add move

water to the internal tank

If there is any doubt regards the quantity of water in the tank we suggest

that you drain the tank and start again adding the 800 mls.

Note!

No need to add water when used in the heating function.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15

No comments

Dimplex DAC12004RC Specifications Page 9