Dimplex DAC12004RC Specifications download pdf (Page 12)

DRAINAGE.

During the process of cooling, water will be generated from the air and collected in the

water tank inside the unit.When the tank is full, the compressor will stop and the Full

Water indicator on the control panel will come on to remind you to empty the water

tank. During this time the fan will continue to operate circulating the air.The water tank

should be emptied as follows:

1. Turn off the unit.

2. Position the supplied plastic water tray,

flat on the floor, under the drain hole.

3. Remove the water stopper and the

rubber plug. Empty the condensed

water from the air conditioner.

4. When the water tray is almost full,

replace the rubber plug to stop the

flow of water, empty the water tray.

5. Repeat step 2, 3, 4, till all the

condensed water is emptied.

6. After all condensed water is drained,

replace the rubber plug and water

stopper.

The FULL WATER indicator should

be off now.

ATTENTION!

1. All condensed water must be drained

prior to relocation or storage.

Continuous Drainage.

In very humid conditions to avoid the unit from continually shutting down when the

water tank is full the unit can also be continuously drained if a convenient drainage

position is available.

Important!

The water is only gravity drained therefore the tube must lay lower and drain at a lower level

than the outlet tube at the rear of the air conditioner.

• Before operating the air conditioner, remove the water stopper, take out the rubber

plug and connect a PVC tube 12mm diameter.

Note!

It maybe necessary to drain more frequently when used in the Heating function.

Water stopper

Rubber

plug

Water

tray

1 2 ... 7 8 9 10 11 12 13 14 15

No comments

Dimplex DAC12004RC Specifications Page 12