Operation
be adjusted for the remainder of
the current event a Temporary
Temperature change can be
done.
Select the Zone that the 3.
temperature change will be
applied.
Using the 4.
and icons
adjust the set point to the
desired temperature.
Select additional Zones if 5.
needed.
!
NOTE: All of the settings will
adjust to the programmed settings
at the next event for each of the
specied zones.
Indenite Temperature Changes
If the temperature in a particular
zone or multiple zones needs
to be adjusted for an indenite
period of time an Indenite Tem-
perature Hold can be done.
Select the Zone that the tem-1.
perature hold will be applied.
Using the 2.
and icons
adjust the set point to the
desired temperature.
Press and hold the 3.
Icon.
Select additional Zones if 4.
needed.
Press the 5.
icon to save the
changes and revert back to
operation mode.
!
NOTE: To exit the hold mode,
the user can press the
icon.
This will remove all holds that
have been applied.
Factory Reset
If the programmed settings need
to be adjusted signicantly, it is
possible to Reset the controller
back to the Factory settings.
Press the 1.
icon.
Press and hold the 2.
icon for
10 seconds.
The unit will return to the initial
set up screen. This is the same
as removing the battery strip after
unpacking.
Comments to this Manuals