Dimplex DF2690 Service Manual download pdf (Page 3)

OPERATION

Figure 1

To access the controls, ip open the control panel cover

towards the bottom of the replace. (Figure 1)

A. On/Off Switch

The On/Off Switch supplies power to all replace functions

(Heater/Flame).

B. Flame Action Control

Turn the Flame Action Control knob to adjust the ame

speed to the desired level.

C. Interior Light Control

Turn the Interior Light Control knob to increase or decrease

the brightness of the upper lights.

D. Thermostat Control

To adjust the temperature to your individual requirements,

turn the thermostat control clockwise all the way to turn

on the heater. When the room reaches the desired

temperature, turn the thermostat knob counter clockwise

until you hear a click. Leave thermostat in this position

to maintain the room temperature at this setting. For

additional heat, turn clockwise until you hear the click again

and the heater will turn on.

E. LED Indicators

Indicates the current function of the replace: Level 1 -

Flame only; Level 2 - Flame and Low Heat; and Level 3 -

Flame with High Heat.

NOTE: When the rebox is changing from Low heat

to High heat the speed of the fan does not change just the

amount of heat being emitted.

F. 3-Position Switch (Figure 3)

The 3-Position Switch operates the replace levels

sequentially, ame only to ame and low heat, to ame and

high heat. The level is increased every time the “ I “ side of

the switch is pressed. The replace can be turned off at any

A DC FEB

Figure 3

3-Position Switch

Level 1 - Flame only

Level 2 - Flame and low heat

Level 3 - Flame and high heat

point by pressing the “ II ” side of the switch.

Level 1: The ame effect is turned on and the rst red

indicator light ashes momentarily.

Level 2: The ame effect remains on, the heater is

activated to the low heat setting, and the rst and second

red indicator lights ash momentarily.

Level 3: The ame effect remains on, the heater is set

to the high heat setting, and all three red indicators ash

momentarily.

NOTE: The heater may emit a slight, harmless odor

when rst used. This odor is a normal condition caused

by initial heating of internal heater parts and will not occur

again.

Figure 2

Resetting the Temperature Cutoff Switch

Should the heater overheat, an automatic cut out will turn

the replace off and it will not come back on without being

reset. It can be reset by switching the On/Off Switch to Off

and waiting ve (5) minutes before switching the unit back

on.

If operating the unit with a remote control, the remote may

require re-initializing after turning the power off.

CAUTION: If you need to continuously reset the heater,

disconnect power and call Dimplex customer service at

1-888-DIMPLEX (1-888-346-7539).

Remote Control

The replace is supplied with a radio frequency remote

control. This remote control has a range of approximately

50 feet (15.25 m), it does not have to be pointed at the

replace and can pass through most obstacles (including

walls). It is supplied with one of hundreds of independent

frequencies to prevent interference with other units.

NOTE: Before attempting any operation with the

remote control, pull the plastic insulator strip out from

between the remote casing and battery cover (Figure 2).

Remote Control Initialization/Reprogramming

This procedure may be required every time there is a loss

of power to the remote control in the replace. (i.e. power

failure, breaker tripped, On/Off switch is turned off)

1 2 3 4 5 6 7 8 ... 15 16

Comments to this Manuals

No comments

Dimplex DF2690 Service Manual Page 3

Comments to this Manuals

Related products and manuals for Fireplaces Dimplex DF2690