Dimplex BF39STP/DXP User Manual download pdf (Page 3)

Listing and Code Approvals

The BF series fireplaces have been tested in accordance with the UL 2021 and CSA C22.2 No. 46 standards for

fixed and location-dedicated electric room heaters.

Model Specifications

Model

Number

Description

Voltage

Volts

Rated Power Watts

Remote

Control

Wall

Thermostat

Refractory

Brick Look

AMPS

No Heat

120 Volt

AMPS

120

Volt

AMPS

208

Volt

AMPS

240

Volt

BF45DXP 45” Deluxe

120/120/

208 /240

245/1440/2100/

2700

Option Option Included 2.0 12.0 10.10 11.25

BF39DXP

39” Deluxe

120/120/

208/240

245/1440/2100/

2700

Option Option Included 2.0 12.0 10.10 11.25

BF39STP 39” Std.

120/120/

208/240

245/1440/2100/

2700

Option Option N/A 2.0 12.0 10.10 11.25

BF33DXP 33” Deluxe

120/120/

208/240

245/1440/2100/

2700

Option Option Included 2.0 12.0 10.10 11.25

BF33STP 33” Std.

120/120/

208/240

245/1440/2100/

2700

Option Option N/A 2.0 12.0 10.10 11.25

Note: Power ratings shown include the light bulbs and motors (275 watts)

The installation of the fireplace unit must comply with the applicable Local and/or National

Electrical Codes and utility requirements. This installation should be entrusted to duly qualified

personnel where required by law.

Step-by-Step Installation

(Note: Please read all instructions before installing)

1. Rough in framing opening following the recommended dimensions located in

(Section A: Framing).

2. Allow 8” of service cable for connecting power supply wire to junction box on fireplace

when installing before finishing wall. Allow up to 4 feet of service cable for connecting

power supply wire to junction box on fireplace when installing after finishing wall.

Remove the outer jacket and strip the individual conductors ½” from the end.

3. Loosen the screw securing the junction box cover and remove the cover.

4. Remove knockouts if necessary or use the provided cable clamp.

5. Place unit in position in the framed opening, level with shims if necessary and attach

unit to frame using mounting flanges provided (see figure 3 on page 3).

6. Unit is factory wired for 208/240 volt power supply (see figure 1 on page 3). If 120 volt

operation is required, slide the switch and reconfigure the wiring

(see figure 2 on page 3). Wires L1, L2, N & G are attached to the rear of the junction

box cable clamp for easy access.

Note

If wiring unit to operate with NO heat a dedicated circuit may not be required.

7. Wire a dedicated, properly fused circuit with a 15amp rating for the appropriate voltage

(120, 208/240). (see Section C for factory setting wiring)

8. Make wall switch and or wall mounted thermostat connections as outlined in Section D:

Wiring.

9. Place all connectors inside the unit and secure the junction box cover to unit. Ensure

that the cable clamp grips only the jacket of service cable, thermostat and if applicable

wall switch lines.

1 2 3 4 5 6 7 8 ... 20 21

Comments to this Manuals

No comments

Dimplex BF39STP/DXP User Manual Page 3

Comments to this Manuals

Related products and manuals for Fireplaces Dimplex BF39STP/DXP