Dimplex BF33DX User Manual download pdf (Page 6)

SECTION C: FACTORY SETTING WIRING

(WITHOUT MAIN POWER WALL SWITCH)

IMPORTANT:

The unit is factory configured for 208/240 volt operation

NOTE:

Use 3 conductor wire with ground (4 wires total) from the power supply (breaker panel) to the

junction box on the unit.

NOTE:

All wiring must be completed prior to installing the unit.

NOTE:

Ensure that the voltage selector switch is in the proper position for the required supply voltage

prior to connecting the unit to the power supply.

240 VOLT INSTALLATION

1. Locate the voltage selector switch inside the exhaust panel on the top right hand

corner of the unit. (see figure 1 on page 3)

2. Ensure that the switch is in the 240 volt position. (230 is printed on switch)

3. Loosen the screw securing the junction box cover and remove the cover.

4. Remove the knockouts (if necessary) or use the provided cable clamp.

5. Pull out the four wires marked L1, L2, N, and G.

6. Connect the black L1 wire from the unit to the black L1 from the power supply.

7. Connect the red L2 wire from the unit to the red L2 from the power supply.

8. Connect the white N wire from the unit to the to the white neutral from the power

supply.

9. Connect the green ground wire from the unit to the ground from the power supply.

10. Ensure that all connections are tight.

11. Insert all the wiring back into the unit and secure with a cable clamp.

FIREPLACE JUNCTION BO

240 V

POWER

SUPPLY

(BREAKER

PANEL)

WHITE WIRE - N

RED WIRE

–

BLACK WIRE

–

GREEN WIRE - G

WHITE WIRE - N

RED WIRE

–

BLACK WIRE

–

GROUND WIRE - G

1 2 3 4 5 6 7 8 9 10 11 ... 23 24

Comments to this Manuals

No comments

Dimplex BF33DX User Manual Page 6

Comments to this Manuals

Related products and manuals for Fireplaces Dimplex BF33DX