Dimplex DF3215NH User's Guide download pdf (Page 5)

NOTE 3

A 15amp, 120 volt circuit is required. A dedicated circuit is preferred but not essential in

all cases. A dedicated circuit will be required if, after installation, the circuit breaker trips

or fuse blows on a regular basis when the heater is operating. Additional appliances on

the same circuit may exceed the current rating of the circuit breaker.

WARNING

Ensure the power cord is not installed so that it is pinched or against a sharp edge and

ensure that the power cord is stored or secured to avoid tripping or snagging to reduce

the risk of fire, electric shock or injury to persons.

Construction and electrical outlet wiring must comply with local building codes and other

applicable regulations to reduce the risk of fire, electric shock and injury to persons.

Do not attempt to wire your own new outlets or circuits. To reduce the risk of fire,

electric shock or injury to persons, always use a licensed electrician.

SITE SELECTION AND PREPARATION

This section provides instructions for selecting a location and preparing the site to install

the fireplace into your Dimplex mantel surround.

1. Select a suitable location that is not susceptible to moisture and is away from

drapes, furniture and high traffic.

2. For ease of electrical hook up you may wish to locate the fireplace near an

existing outlet. (refer to NOTE 3)

3. Store the fireplace in a safe dry and dust free location.

NOTE 4

The dimensions of the fireplace are 36 ½”wide X 31 ¾” high X 13” deep. The viewing

area is 32” wide and 28 ¼” high. The fireplace does not require any additional venting.

Model Number

Serial Number

Carton

Firebox

1 2 3 4 5 6 7 8 9 10 ... 17 18

No comments

Dimplex DF3215NH User's Guide Page 5