Dimplex DCF44B Instruction Manual download pdf (Page 13)

13

Maintenance

Light Bulb Replacement

CAUTION: Allow at least ve

(5) minutes for light bulbs to cool

before touching bulbs to avoid

accidental burning of skin.

!

NOTE: Light bulbs need to be

replaced when you notice a dark

section of the ame or when the

clarity and detail of the log ember

bed exterior disappears. There

are three (3) bulbs under the log

set, which generate the ames

and embers, and two (2) bulbs

above the log that illuminate the

log exterior.

Lower Light Bulb Requirements

Quantity of three (3) clear

chandelier or candelabra bulbs

with an E-12 (small) socket base,

60 Watt rating. Example: GE

60BC or Philips 60 CTC.

Do not exceed 60 Watts per

bulb

Helpful Hints: It is a good idea to

replace all light bulbs at one time

if they are close to the end of their

rated life. Group replacement will

reduce the number of times you

need to open the unit to replace

light bulbs. Care must be taken

when removing the logset as the

logset contains LED’s and wires.

To access the lower light bulb

area (Figure 5):

Remove front glass assembly.1.

Pull the front edge of the 2.

plastic ember bed or plastic

grate up and forward until the

rear tab releases from the

ledge located at the bottom of

the partially reective glass.

Figure 5

Upper Bulbs

Log Set

Lower Bulbs

LED

Wire Harness

Front

Glass

!

IMPORTANT: Only handle the

logset by the emberbed.

!

NOTE: Logset ts tightly

into rebox, some force may be

necessary to remove.

Set logset in front of replace.3.

Disconnect the logset LED 4.

wire harness from unit.

Unscrew bulbs counter 5.

clockwise.

Insert new bulbs.6.

Reconnect the logset LED 7.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 52 53

Comments to this Manuals

No comments