Dimplex DFI600LH Service Manual download pdf (Page 8)

8 www.dimplex.com

push the switch out through the opening.

5. Properly orient and insert the new switch and connect

all of the wiring.

6. Re-assemble the remainder of the cassette in reverse

order from the instructions above.

POTENTIOMETER REPLACEMENT

Tools Required: Philips head screwdriver

Flat Head Screwdriver

3/8” (10mm) Wrench

WARNING: Disconnect power before attempting any

maintenance to reduce the risk of electric shock or damage

to persons.

NOTE: Ensure that all of the components that

contain water have been emptied before performing any

maintenance.

1. Disconnect and remove the media from the unit and

put them in a safe place.

2. Remove the 4 screws that secure the front grill to the

cassette housing. (Figure 4)

3. Turn the unit so that the underside of the potentiometer

can be seen.

4. Loosen the securing nut, to allow the potentiometers

slide out.

5. Disconnect the wiring connections noting their original

locations.

NOTE: A at head screwdriver can be used to gently

pry between the end of the connector and the switch to

release the wires.

6. Slide the potentiometer back into the assembly and

tighten the securing nut.

7. Re-assemble the remainder of the cassette in reverse

order from the instructions above.

POWER CORD REPLACEMENT

Tools Required: Philips head screwdriver

Flat head screwdriver

WARNING: Disconnect power before attempting any

maintenance to reduce the risk of electric shock or damage

to persons.

NOTE: Ensure that all of the components that

contain water have been emptied before performing any

maintenance.

1. Disconnect and remove the media from the unit and

put them in a safe place.

2. Remove the 4 screws that secure the front grill to the

cassette housing. (Figure 4)

3. Locate the cord and disconnect the wiring connections

noting their original locations.

NOTE: A at head screwdriver can be used to gently

pry between the end of the connector and the switch to

release the wires.

4. With needle nose pliers, grasp the cord strain relief

grommet from inside the back of the bottom panel and

push while twisting to remove.

5. Install the new cord.

6. Reassemble in the reverse order as above.

LIGHT ASSEMBLY REPLACEMENT

Tools Required: Philips head screwdriver

Flat Head Screwdriver

WARNING: Disconnect power before attempting any

maintenance to reduce the risk of electric shock or damage

to persons.

NOTE: Ensure that all of the components that

contain water have been emptied before performing any

maintenance.

1. Disconnect and remove the media from the unit and

put them in a safe place.

2. Disassemble the sump components. (Figure 3)

3. With the unit turned upside down, remove the 2 screws

that hold the light assembly to the unit. (Figure 5)

4. Remove the light assembly and replace with the new

light assembly.

5. Reattach the wire onto the new light assembly.

6. Re-assemble the remainder of the cassette in reverse

order from the instructions above.

FAN ASSEMBLY REPLACEMENT

Fan Motor and Fan Housing

Tools Required: Philips head screwdriver

Flat Head Screwdriver

WARNING: Disconnect power before attempting any

maintenance to reduce the risk of electric shock or damage

to persons.

NOTE: Ensure that all of the components that

contain water have been emptied before performing any

maintenance.

Figure 5

1 2 3 4 5 6 7 8 9 10

Comments to this Manuals

No comments

Dimplex DFI600LH Service Manual Page 8

Comments to this Manuals

Related products and manuals for Fireplaces Dimplex DFI600LH