Dimplex DF2500L Owner's Manual download pdf (Page 7)

7

Fireplace Installation

!

NOTE: A 15 Amp, 120 Volt

alternating current (VAC) circuit

is required. A dedicated circuit

is preferred but not essential in

all cases. A dedicated circuit will

be required if, after installation,

the circuit breaker trips or fuse

blows on a regular basis when the

heater is operating. Additional

appliances on the same circuit

may exceed the current rating of

the circuit breaker.

WARNING: Ensure the power

cord is not installed so that it is

pinched or against a sharp edge

and ensure that the power cord is

stored or secured to avoid tripping

or snagging to reduce the risk

of re, electric shock or injury to

persons.

Construction and electrical outlet

wiring must comply with local

building codes and other applica-

ble regulations to reduce the risk

of re, electric shock and injury to

persons. Do not attempt to wire

your own new outlets or circuits.

To reduce the risk of re, electric

shock or injury to persons, always

use a licensed electrician.

1. Make sure the units 3-Posi-

tion switch is switched OFF

(refer to operating instruction

section).

2. Plug the unit into a 15

Amp/120 VAC outlet.

Front Glass Installation

1. Unpack the glass assembly.

2. Hang bottom bracket on

screw at the bottom of the

rebox. (Figure 1)

3. Secure the top bracket to re-

box using screws provided in

the hardware bag. (Figure 1)

Mantel Installation

For use with a new or existing

mantel. Depending on the avail-

able space within the mantel cav-

ity, the unit can be secured to the

mantel at the bottom side or back.

Remove the screw on the bottom

Figure 1

1 2 3 4 5 6 7 8 9 10 11 12 ... 43 44

Comments to this Manuals

No comments