Dimplex BFSL33 Installation Guide download pdf (Page 3)

LISTING AND CODE APPROVALS

The BF series replaces have been tested in accordance with the UL 2021 and

CSA C22.2 No. 46 standards for xed and location-dedicated electric room

heaters.

Voltage

Volts

Rated

Power

Watts

Remote

Control

Wall

Thermostat

AMPS

No Heat

120 Volt

AMPS

120

Volt

AMPS

208

Volt

AMPS

240

Volt

120/120/

208/240

8/1223/

1823/2423

Std. Option 0.07 10.2 8.7 10.1

NOTE: Power ratings shown include LED lights and motors (10 watts)

WARNING: The installation of the replace unit must comply with the ap-

plicable Local and/or National Electrical Codes and utility requirements.

This installation should be entrusted to duly qualied personnel where

required by law.

MODEL SPECIFICATIONS

STEP-BY-STEP INSTALLATION

(

NOTE: Please read all instructions before installing)

Rough in framing opening following the recommended dimensions located 1.

in (Section A: Framing).

Allow 8” of service cable for connecting power supply wire to junction box 2.

on replace when installing before nishing wall. Allow up to 4 feet of

service cable for connecting power supply wire to junction box on replace

when installing after nishing wall. Remove the outer jacket and strip the

individual conductors ½” from the end.

Loosen the screw securing the junction box cover and remove the cover.3.

Remove knockouts if necessary or use the provided cable clamp.4.

Place unit in position in the framed opening, level with shims if necessary 5.

and attach unit to frame using mounting anges provided (see gure 3 on

page 3).

Unit is factory wired for 208/240 volt power supply 6. (see gure 1

on page 6). If 120 volt operation is required, slide the switch and

recongure the wiring (Section C). Wires L1, L2, N & G are at-

tached to the rear of the junction box cable clamp for easy access.

NOTE: If wiring unit to operate with NO heat a dedicated circuit may

not be required.

Wire a dedicated, properly fused circuit with a 15amp rating for the appro-7.

priate voltage (120, 208/240). (see Section C for factory setting wiring)

Make wall switch and or wall mounted thermostat connections as outlined 8.

in Section D.

Place all connectors inside the unit and secure the junction box cover to 9.

unit. Ensure that the cable clamp grips only the jacket of service cable,

thermostat and if applicable wall switch lines.

1 2 3 4 5 6 7 8 ... 21 22

Comments to this Manuals

No comments

Dimplex BFSL33 Installation Guide Page 3

Comments to this Manuals

Related products and manuals for Fireplaces Dimplex BFSL33