Operation
③ Wait a minimum of ve (5)
seconds and then re-acquire
power to stove.
④ Within 10 seconds of re-
acquiring power, press the ON
button located on the remote
control transmitter.
!
NOTE: You will have only 10
seconds to perform this last
step. Failure to do so will result
in these steps needing to be
followed again.
WARNING: Disconnect
power before attempting any
maintenance or cleaning to
reduce the risk of re, electric
shock or damage to persons.
Light Bulb Replacement
Allow at least ve (5) minutes
for light bulbs to cool off before
touching bulbs to avoid accidental
burning of skin.
Light bulbs need to be replaced
when you notice a dark section
of the ame or when the clarity
and detail of the log exterior
disappears.
There are three (3) bulbs under
the Log Set Assembly, which
generate the ames and embers,
Maintenance
and one (1) bulb above that
illuminate the log exterior.
Tool Requirements:
Phillips screw driver
Helpful Hints
It is a good idea to replace all
light bulbs at one time if they are
close to the end of their rated life.
Group replacement will reduce
the number of times you need
to open the unit to replace light
bulbs.
Upper Bulb Requirement
Quantity of one (1) 7 Watt
candelabra E12 small base
120 Volt.
Do not exceed 7 Watts per bulb.
Comments to this Manuals