Stove Installation
WARNING: This stove is
not to be used on elevated
surfaces.
Site Selection
!
NOTE: A 15 Amp, 120 Volt
alternating current (VAC)
circuit is required. A dedicated
circuit is preferred but not
essential in all cases. A
dedicated circuit will be
required if, after installation,
the circuit breaker trips or
fuse blows on a regular basis
when the heater is operating.
Additional appliances on the
same circuit may exceed the
current rating of the circuit
breaker.
WARNING: Ensure the
power cord is not installed so
that it is pinched or against a
sharp edge and ensure that
the power cord is stored or
secured to avoid tripping or
snagging to reduce the risk of
re, electric shock or injury to
persons.
Construction and electrical
outlet wiring must comply
with local building codes and
other applicable regulations to
reduce the risk of re, electric
shock and injury to persons.
Do not attempt to wire your
own new outlets or circuits. To
reduce the risk of re, electric
shock or injury to persons,
always use a licensed
electrician.
Installation
①
Remove all packaging from
unit and ensure heater exhaust
Quick Reference Guide
① The information regarding the
model of your electric stove can
be found on the label located on
the back of the unit.
② If you have any technical
questions or concerns regarding
the operation of your electric
stove, or require service contact
customer service.
Comments to this Manuals